This is just a quick little tag that can stand alone or be incorporated into a card. I’d like to thank a UK fellow demo for the idea…Sam Donald.
Start with a piece of cardstock 2″ x 8″ (Note: You can make the length as long or short as you like)
Use DSP scraps to punch out the flowers and background for window flower.
Fold the cardstock in half, burnish and using the Scalloped Tag Topper, punch each end.
Using your Petite Petals Punch – slide it in across the side as far as it will go (near the bottom) and punch. While you have the punch go ahead and punch out 3 flowers from your scraps of DSP.
Use the edges of your Stampin’ Dimensionals sheet and put around the punched out flower. Put a scrap of DSP on the opposite side of the window.
Run SNAIL along the edges of the back but NOT on the DSP. Pull the paper off your Stampin’ Dimensionals and close matching the tag toppers.
Round the bottom corners and sponge the edges.
Push the round end of your paper piercer into each flower and then use glue dots to put in place. Embellish each flower with a Candy Dot, Pearl or Rhinestone. Slip ribbon through the top hole and you are finished!
These are just so cute and easy…enjoy!